mountz美国蒙士混合无刷电动螺丝刀扭矩控制系统PHD50N-A[产品打印页面]

Brushless Electric Screwdrivers

• Various models that range from 4.4 - 86.8 lbf.in
• Electric Screwdrivers feature a high performance brushless motor design that provides durability and reduces the standard maintenance costs for electric screwdrivers.
• ESD housing and bit tip control to 1 ohm, (cable not ESD).
• Low inertial force provides smooth reaction-less operation with little G force to assembled parts.
• Low noise, vibration and maintenance.

Controller

• Programmable digital torque setting with memory for 8 preset torque settings.
• Real-time monitoring and torque control of the tightening process.
• Selectable speed up to 1,800 rpm.
• Programming and monitoring with PC software.
• Programmable multi-sequence operation.

Preset Parameter Settings

• Three selectable units of measure: lbf.in, N.m, Kgf.cm.
• Selectable settings for Torque, Speed, Min & Max Angle, and Soft Start time.
• Maximum angle control and verification
• Minimum angle control and error reporting

• Detection of fastening error and displays error condition.
• Visual assembly fastener count (count up or down), including total count.
• Real time monitoring by PC program.
• Detects - cross threading, omissions, unfinished rundowns and cycle complete.
• 0 to 99 screws

• 25P I/O interface to a PLC or 8 direct sensor ports.
• Sensor ports for preset selection and screw counting.
• Input via sensor ports for presets.
• Input / Output for PLC.

• Auto
• Start (Continuous on)
• Start Pulse with time limit
• Start Pulse and Finish pulse

Motor Run Time Limits

• Motor run time limits, forward and reverse.
• Motor stall time limit.
• Sleep time.
• Motor acceleration for soft start.

• Count complete
• Torque up and Count complete
• Alarm, screw missing

• Preset and Speed.
• Preset and Torque.
• Converted Torque Idle & Target Torque (Running)
• Count setting and remaining screw count.
• Count setting and remaining screw count (Idle)
  + Preset and Torque (Running).
• Count setting and remaining screw count +
  Preset and Torque (Alternating).